User manual

Installation
Fitting under a counter
Warning! Make sure that mains plug is
disconnected from the mains socket during
installation.
Put the appliance adjacent to a water tap and a water
drain.
The plinth on freestanding appliance is not adjustable.
Do not remove the appliance worktop if you want to use
the dishwasher as a freestanding appliance.
Remove the appliance worktop to install it under a sink
unit or a kitchen worktop.
Make sure that the dimensions of the recess agree with
the given dimensions.
1
2
3 4
Adjusting the level of the appliance
Make sure that the appliance is level to close and seal
the door correctly. If the level of the appliance is correct,
the door does not catch on the sides of the cabinet. If
the door does not close correctly, loosen or tighten the
adjustable feet until the appliance is level.
Adhesive steam protection foil
If the worktop is removed, fit the steam protection onto
the front part of the kitchen cabinet benchtop.
The steam protection foil is not supplied with free-
standing models, but can be purchased form
Electrolux Spare Parts.
Water connection
Water inlet hose
Connect the appliance to a cold water supply.
Connect the inlet hose to a water tap with an external
BSP thread spout of 3/4”.
Inlet water supply
• Cold water pressure: 800 kPa max - 50 kPa min.
• Water flow rate 10 L / minute min.
• If cold water pressure is in excess of 800 kPa, a
pressure reducing valve should be used. Check for
leaks.
Caution! Always use new hoses when you
connect the appliance to the water mains. Old
hoses must not be used. The water inlet hose must be
examined at an interval of twelve months for
deterioration and replaced if necessary.
16