User manual

Frost precautions
Caution! Do not install the appliance where the
temperature is below 0 °C. The manufacturer is
not responsible for damage because of frost.
If not possible, empty the appliance and close the door.
Disconnect the water inlet hose and remove water from
the water inlet hose.
Moving the machine
Do these steps to move the appliance:
1. Disconnect the mains plug from the mains socket.
2. Close the water tap.
3. Remove the appliance and the hoses.
4. Do not tilt the appliance during transport.
What to do if…
The appliance does not start or stops during operation.
If there is a fault, first try to find a solution to the problem
yourself. Refer to following charts. If you cannot find a
solution to the problem yourself, contact your dealer or
the Customer Care Centre.
Warning! Switch the appliance off before you do
the suggested corrective actions.
Malfunction Fault code Possible cause Possible solution
The appliance
does not fill with
water
the digital display shows
The water tap is blocked or
restricted with limescale.
Clean the water tap.
The water pressure is too
low.
Contact your local water au-
thority.
The water tap is closed. Open the water tap.
The filter in the water inlet
hose is blocked.
Clean the filter.
The installation of the water
inlet hose is not correct. The
hose can be kinked or
squashed.
Make sure that the installa-
tion is correct.
The appliance
does not drain
the water
the digital display shows There is a blockage in the
sink spigot.
Clean the sink spigot.
The installation of the water
drain hose is not correct. The
hose can be kinked or
squashed.
Make sure that the installa-
tion is correct.
The anti-flood
device operates
the digital display shows
Close the water tap and con-
tact your Customer Care
Centre.
The program
does not start
The appliance door is not
closed.
Close the door.
Mains plug is not connected. Plug-in appliance to the
mains.
13