User Manual

Attach the Steering
Rod and Handlebars
1. Insert the steering rod
down through the hole
on top of the car body.
The tabs on the base of
the handlebars should t
into the slots in the
handlebar hole.
2. The curve of the steering
rod should insert into the
slot between the steering
bracket. The end of the
steering rod should insert
into the hole on the
bottom of the steering
bracket.
3. Place the washer over
the bottom of the
steering rod and secure
with the nut.
Note: The washer
and bolt will come
attached to bottom of
the steering column.
4. Fasten the nut to the
end of the steering rod
and tighten with the
hex wrench.
5. Attach the wire connector
coming from the steering
column to the wire
connector coming from the
underside of the car body.
6
handlebar
slot
handlebar
tab
steering rod
washer
nut
hex wrench
Steering
rod slot
Steering
rod hole
2
1
5
3
4