Use and Care Guide
Assembly Instructions
Package Contents
Do’s and Don’ts
1. Do check your inatable daily and adjust
to stand up straight.
2. Do not attempt to operate your inatable
in unusually strong winds.(see caution)
3. Do not unplug by pulling on cord. For
faster deation, unzip zipper after
unplugging power supply.
7
A
D
Ensure that the air intake on the
inatable (A) unit is clear of fabric and
other obstructions and that the zipper
is fully closed. Some inatables have
more than one zipper.
Connect UL- Listed power supply (D) into
connection of fan, plug power supply into
standard wall outlet .
Once fully inated, clip the nylon tethers
(B) to each of the attached nylon loops on
the side of the inatable (A).
Using the loops attached at the bottom
of the Inatable unit (A), insert stakes (C)
into the ground. Adjust weight-bag at the
base to position your Inatable as desired.
Drive the stakes (C) into ground at a
45-degree angle.
For maximum stability, bring tether down
to a 45-degree angle from the inatable as
shown in the illustration. In order to achieve
this you may need to wrap the excess
tether around the top of the stake.
3
5 6
A
C
A
C
4
2
A
B
B
1
Part Description Quantity
A Airblown
®
Inatable 1
B Tethers 2
C Stakes 4
D
UL - listed Power supply
Input:120-150VAC ~ 50/60Hz
Output: 12 V
1.0A
1
D
D
B
C
Visit
WWW.GEMMY.COM
for more information.
©2018 GEMMY INDUSTRIES CORP.
117 WRANGLER DRIVE. SUITE 100
COPPELL, TX 75019 U.S.A.
1 (877) 250-9032
MADE IN CHINA / PRINTED IN CHINA
7
Do
Don’t