PL3060 PlasmaLift Installation & Owners Manual READ ALL INSTRUCTIONS BEFORE BEGINNING INSTALLATION Installation notes Physical Installation Cabling Contact Closure Operation/Programming Drawing – all views Drawing – bill of materials 2 2, 3 3 4 5 6 February 2007 tel: 303.412.0399 fax: 303.412.9346 www.displaydevices.com tech@displaydevices.com 5880 Sheridan Blvd.
IP406-001 RevC PL3060 Lift Installation PL3060 PlasmaLift Installation Instructions Thanks for purchasing a Display Devices lift product. We’re sure your customer will use this lift for years to come. Our products are designed to be maintenance free saving you future service time. If you experience any difficulties, please contact us at 303-412-0399. Thank you for your support.
IP406-001 RevC PL3060 Lift Installation Cable Management Begin at fixed pivot point End point Loop under Loop over Loop under Begin at fixed pivot point 13. Operate the lift up and down a few times to be sure that are no cables binding anywhere on the lift. 14. Verify that when the door is shut it is level with the unit frame, if not adjust the all-thread arms on the left and right sides as needed.
IP406-001 RevC PL3060 Lift Installation Programming Show Position Programming can only be done with three-button control. If other methods of triggering the lift are normally used, first program the lift with the buttons and then configure lift for the other trigger method. 1.) Press ‘HOME’ button. Unit rises to the home or stored position. 2.) Press and hold ‘STOP’ button for 10 seconds – unit is now in manual mode. 3.) Press ‘SHOW’ button momentarily – unit will travel down.
DRAWING REVISION BLOCK REV ER A DESCRIPTION DRA WN RELEA SED FOR PRODUCTION JTW CHECKED A PPROV ED DA TE 3/ 31/ 2003 19.000 .500 20.500 65.000 49.500 32.000 34.000 16.500 1.000 0 12X 17.00 44.00 9.495 66.00 41.845 RETRACTED DISPLAY DEVICES, INC EXTENDED THE INFORMATION CONTAINED UNLESS OTHERWISE SPECIFIED DIMENSIONS ARE IN INCHES. IN THIS DRAWING IS THE PROPERTY OF DISPLAY TOLERANCES: DEVICES, INC. ANY REPRODUCTION IN PART .XX = .02 OR WHOLE WITHOUT THE .XXX = .
10 5 6 4 12 11 13 11 2 7 8 9 1 ITEM NO QTY PART NO DESCRIPTION 1 1 406-003 FRAME ASSY 2 1 406-004 MOTOR & DRUM ASSY 3 1 406-005 SLIDE ASSY 4 4 5900-1260 1/4-20 X 1/2, HHCS, HX, GR5, PL 5 4 5950-1220 1/4, FL WASHER, SAE, STL, ZI 6 4 5950-1325 1/4, LK WASHER, STL, PL 7 8 5900-1585 5/16-18 X 3/4, HHCS, HX, GR5, PL 8 8 5950-1230 5/16, FL WASHER, STL, ZI 9 8 5950-1070 5/16, LK WASHER, STL, PL 10 4 3/8-16 X 2.