PL3200 PlasmaLift Installation & Owners Manual July 2001 sales @ displaydevices.com (303) 412-0399 fax: (303) 412-9346 www.displaydevices.com 5880 N.
PL3200 PlasmaLift Installation Instructions Ensure the ceiling structure is capable of holding at least four times the combined weight of the lift and projector. This is a minimum requirement. Also ensure that the ceiling structure is capable of holding at least four times the combined weight of the lift and projector. Again, this is a minimum requirement. Follow any local or state codes that apply to your specific area. 1.
PL3200 PlasmaLift Programming Show Position Programming can only be done with three-button control. If other methods of triggering the lift are normally used, first program the lift with the buttons and then configure lift for other trigger method. 1.) Press ‘HOME’ button. Unit raises to the home or stored position. 2.) Press and hold ‘STOP’ button for 10 seconds – unit is now in manual mode. 3.) Press ‘SHOW’ button momentarily – unit will travel down.
PL3200 PlasmaLift Control Interface 8 7 6 Control Box Side View 4 3 2 1 Low-Voltage Control Lines: There are three integrated methods of control and two optional methods. The standard controls are three momentary buttons (contacts) or low-voltage control signal, or single-latching contact. The optional methods are remote IR or RF control. Please contact DDI for information on those options.