SE-B2, B3 & BXL Sound Enclosures Installation Manual READ ALL INSTRUCTIONS BEFORE BEGINNING INSTALLATION 03/08 tel: 303.412.0399 fax: 303.412.9346 1 5880 Sheridan Blvd., Arvada, Colorado 80003 www.displaydevices.com tech@displaydevices.
SE-B2, B3 & BXL Series Sound Enclosures Thanks for purchasing a Display Devices product. We’re sure your customer will use this product for years to come. Our products are designed to be maintenance-free saving you future service time. If you experience any difficulties, please contact us at 303-412-0399. Thank you for your support. The Sound Enclosure is designed to relocate projector noise to above a false ceiling. Sound Enclosures work best when installed as part of a complete sound isolation system.
5.) To attach the fire dampers to the intake and exhaust ports, use the enclosed Phillips-head sheet metal screws. 6.) Add runs of ductwork on the intake and exhaust fire dampers. Addition of ducts disperses the sound above the ceiling further away from the projector. Sound isolating ductwork is recommended. If additional sound dampening is desired, we recommend an auto sound insulation material. 7.
19.) See the temperature controller section below to set fan temperature settings. ½” Mounting holes Cable Knock-outs Finished Ceiling Level Fire Dampers Access Panels 03/08 tel: 303.412.0399 fax: 303.412.9346 4 5880 Sheridan Blvd., Arvada, Colorado 80003 www.displaydevices.com tech@displaydevices.
Temperature Controller Operation The Programmable Cooling System provides two levels of fan control, an audible alarm, switched AC power-down, and displays the current temperature of the enclosure. Factory presets: Fan set 1: Fan set 2: Alarm: Power off: 70° 74° 100° 104° To start operation, turn plug in the power supply. The controller may sound an alarm, and the fans will turn on for 10 to 20 seconds. The system will then reset to a start state.
Programming: There are four parameters to program. Each is programmed in the same sequence. The control panel has four pushbuttons labeled SELECT MENU, Cursor UP, Cursor DOWN and SAVE. The associated Power Supply is provided with an IEC AC power cord and On / Off switch. LED Display: The LED display provides two rows of text. When the system is powered up, the LED display will read “Display Devices” and “Current Temp (number).” The twodigit number indicates the current temperature.
03/08 tel: 303.412.0399 fax: 303.412.9346 7 5880 Sheridan Blvd., Arvada, Colorado 80003 www.displaydevices.com tech@displaydevices.
03/08 tel: 303.412.0399 fax: 303.412.9346 8 5880 Sheridan Blvd., Arvada, Colorado 80003 www.displaydevices.com tech@displaydevices.