Datasheet

DEM 16227 SYH-LY Product Specification
VERSION: 2 PAGE: 14
6．Defects and Acceptance Standards
6.1 Electrical properties test
No. Defects Description
Accepted
standard
MAJ MIN
6.1.1
Missing
segment
Dot and character missing segment caused by its
wire broken/poor contact(s) and internal open
circuit.
Reject
√
6.1.2
No display/
reaction
The products no picture display under normally
connected situation.
Reject
√
6.1.3
Mis-display/
abnormality
display
Displaying pattern and sequence not conform to
the requirement or abnormally display when
scanning as per the correct procedure.
Reject
√
6.1.4
Wrong
viewing angle
When powered on, the clearest viewing direction of
display pattern is not conform to the requested
one(or not conform the direction of the customer
approved samples)
Reject
√
6.1.5
Dim or dark
display
Overall contrast is either too dark or too dim under
normal operation
Beyond the
voltage
tolerance, reject
√
6.1.6
Response
slowly
When power on or off some parts response time is
different from others.
Reject
√
6.1.7
Exceed
segment
As misalignment and insufficient etching caused
abnormally display, display with exceed pattern or
display with abnormally symbol, row or columns
when power on.
Refer to the
dot/line standard
√
6.1.8
PI black/
white spot
Partial black and white spots visible when
changing display contents due to defective PI
layer.
Refer to the
spot/line criteria
for the visible
spots when
display image
remains still;
others OK
√
6.1.9
Pinhole /white
spot
Fragmental patterns appearing when it powered
on caused by missing ITO.
d = (X+Y)/2
Refer to the
dot/line standard
√ Y
X