User's Manual

4 Dynamic Communicator Installation Guide

Dynamic Communicator Displaydata Table of Contents

Mounting Installation

The dynamic communicator should be vertically mounted with the antennas pointing

downwards.

An installation template to aid mounting can be downloaded from the Displaydata

Support website.

Connecting the Dynamic Communicator

1. Ethernet Port

2. DC Input

3. Factory reset - DO NOT USE. Warning this will erase user data!

4. SD Card slot - DO NOT USE. Reserved for future expansion.

5. RF Antennas – note orientation for optimum performance.

6. Power Status LED – indicates green when unit is correctly powered.

Turning the unit on

Option 1: Power over Ethernet (IEEE 802.3af)

Option 2: DC Power Supply (Sold Separately)

Important:

Connect network cable first, then power supply.

PSU must be rated as follows: -

Output: 5.0V/1.2A or 5.2V/1.2A

Displaydata