User's Manual

Sensor RF module 2AA (US) User Manual
This transmitter must not be co-located or operating in conjunction with any other antennas or
transmitters. It is the responsibility of the host device manufacturer to ensure continued
compliance with FCC rule part 15B once the module has been installed in the host device.
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
The concerned end product must be labeled to say
“Contains FCC ID: 2ATFX-102540”
Industry Canada statements
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
1) The device may not cause interference, and
2) The device must accept any interference, including interference that may cause undesired
operation of the device.
Important note: To comply with Industry Canada RF exposure limits, the antenna used for this
device must be installed to provide a separation distance of at least 20cm from all persons. RF
exposure is in accordance with RSS-102, section 2.5.2.
The concerned end product must be labelled to say:
“Contains IC: 25087-102540”
Declarations d’Industry Canada
Cet equipement est conforme aux normes d’exemption de licence RSS d’Industry Canada. Son
utilisation est soumise aux deux conditions suivantes:
1) Le dispositif ne doit pas provoquer d’interference, et
2) Le dispositif doit accepter toute interference, y compris des interferences susceptibles de
provoquer un fonctionnement indesirable de l’equipement.
Remarque importante: Pour respecter les limites d’exposition aux radiofrequences d’Industry
Canada, l'antenne utilisée pour cet appareil doit être installé pour fournir une distance de
séparation d'au moins 20 cm de toutes les personnes. L'exposition aux RF est conforme à la
norme RSS-102, section 2.5.2.
Le produit final concerne doit porter une etiquette avec la mention:
"Contient IC: 25087-101941"
4. Block Diagram
The block diagram of the Sensor RF module 2AA (US) is shown in figure 1.
Disruptive Technologies AS - Public 4 of 7