User Manual
For support and more information about
our products, visit: d21s.com/suppor
Disruptive Technologies Research A
Strandveien 17, 1366 Lysaker, Norwa
TM and © 2023 Disruptive Technologies
Reserach AS. All rights reserved
Designed in Norway,
Assembled in Germany.
Safety & Us
Manual
Cloud Connector E
Frequency Band ISM 868 MH
Transmit Power < 100 m
Celluar Version
LTE Cat-
LTE FDD: B1/B3/B7/B8/B20/B2
Output Power: LTE Power Class 3 (23 dBm ± 2 dB
CE: Hereby, Disruptive Technologies Research AS declares that the radio equipment
model 102505 and model 102673 are in compliance with Directive 2014/53/EU. The full
text of the EU declaration of conformity is available at the following internet address:
www.d21s.com/do
UK: Hereby, Disruptive Technologies Research AS, declares that the radio equipment
model 102505 and model 102673 are in compliance with UK SI 2017, No 1206: Radio
Equipment Regulations. The full text of the UK DoC can be found at the following web
address: www.d21s.com/do
Cloud Connector U
Frequency Band ISM 915 MH
Transmit Power < 100 m
Celluar Version
LTE Cat-M
LTE FDD: B2/B4/B5/B12/B13/B25/B26/B66/B8
Output Power: LTE Power Class 5 (21 dBm ± 1.5 dB
Compliance statement: www.d21s.com/do
FCC: This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation
This device complies with FCC radiation exposure limits for an uncontrolled
environment. This device shall be installed and operated with a minimum distance of 20
cm between users or bystanders and the device
ISED: This device contains license-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science, and Economic Development Canada’s license-exempt RSS(s).
Operation is subject to the following two conditions
(1) This device may not cause interferenc
(2) This device must accept any interference, including interference that may cause
undesired operation of the devic
This equipment is exempt from the routine RF exposure evaluation requirements of
RSS-102. This equipment should be installed and operated with a minimum distance of
20 cm between the antenna and the user or bystanders
Please read this guide before
attempting to operate the product
Failure to follow these instructions may result in an
increased risk of personal injury or damage to property,
including through re, electrical shock, burns or suocation.
Disruptive Technologies Research AS shall not be liable for
damage caused where the product owner has failed to
follow the instructions set out in this guide
No changes shall be made to the equipment without the
manufacturer’s permission as this may void the user's
authority to operate the equipment.
Warnings
Do not use outdoors
Use in a dry environment
Do not plug in a damaged device
Do not remove screws or open device
The mounting bracket must be secured with screws if
installed above 2 meters.
The Ethernet port must only be connected to a LAN
within the same mains ring
Unplug the power supply unit from the mains if the
device is not in use.