User Manual

SAFETY PRECAUTIONS IN USE
1. The input voltage of the appliance is AC220-240V〜50Hz. Please confirm it before
using the appliance.
2. Do disconnect the power supply before dismantling, assembling or adjusting any
part of the appliance.
3. The appliance has Y connection. If its power cord is damaged, please contact our
customer service department or have it directly replaced at a service center designated
by us to avoid dangers. Do not dismantle and repair it by yourself.
4. Before use, please check if the power cord, the plug, the juice strainer, the spiral
pusher and any other part is damaged. If any of the part is damaged, stop using the
appliance and contact our customer service department promptly. Do not dismantle and
repair it by yourself, otherwise dangers may happen.
5. If it is necessary to repair the appliance during use, please contact our customer
service department or have it directly repaired by a service center designated by us. Do
not dismantle it by yourself, otherwise dangers may happen.
6. It is necessary before connecting the power supply to ensure that the juicing body,
the spiral pusher, the juicing body cap and all other dis-mountable parts are properly
installed.
7. Never put hands or sharp objects into the feed port or contact the spiral pusher
when the appliance is running, otherwise injuries may be caused or the appliance may be
damaged; never replace the spiral pusher with any other objects or have eyes get close to
the feed port, otherwise accidents may happen.
8. Cut food ingredients into small blocks with sizes fitting the feed port of the juicing
body. Do not begin to process any vegetables or fruits with cores, hard seeds or thick skin
or shells until the cores, hard seeds or thick skin or shells are removed.
9. When feeding a food ingredient, do not make the pushing force too large but have
it just enough to cut the food ingredient.
10. Dyeing of the juice strainer, the juicing body cap, the spiral pusher and other acces-
sories after juicing of some vegetables or fruits is normal and will neither affect food
eating nor do harm to health.
11. Equipped with an intelligent protective chip, the appliance will stop automatically
after 20 minutes of continuous running. In this case, wait for 20 to 30 minutes before conti-
nuous use until the motor has cooled down to prolong the service life of the appliance.
12. The appliance has a current limiting design, so its motor will get locked and its
current will increase when hard food ingredients are processed. When the current is larger
than 1.3A, the appliance will tick and the motor will pause for 2 seconds, then reverse auto-
matically for 5 seconds and finally stop running (the food in the appliance can be
discharged when the motor reverses). In this case, the appliance can begin to run again
after the ON/OFF button is put on the “0” position.
13. If the appliance has current limiting protection or its motor is locked and stops
automatically and cannot reverse automatically, switch off the power switch and put it on
the “0” position, then press the “ON” button of the power switch to discharge the food
ingredients in the appliance and finally press the “R” button of the power switch for normal
use of the appliance. If the motor is still locked, it is suggested to remove the food ingre-
dients in the spiral pusher before continue to use the appliance. This measure can protect
the motor.
10