User Manual

Before using the appliance for the first time, clean its parts in contact with food

ingredients thoroughly (please refer to “Chapter 4: Maintenance”).

Button operation instructions:

“Soft”: It is used for juicing soft food ingredients.

“Hard”: It is used for juicing hard food ingredients.

“0” : Close and stop

“Rev” : It is used when pulp discharge is blocked or the

motor is locked

Connect the juicing body and the main body:

1. Have the triangular aligning sign “” on the juicing

body align with the aligning “unlocking triangular sign”

on the main body and then put the juicing body into the

main body (the three clips on the juicing body will realize

alignment).

2. Then turn the juicing body anticlockwise. When

there is a click, it suggests that the connection is finished.

Have the hexagonal shaft of the spiral pusher align with

the hole on the main body and push it horizontally until it

reaches the bottom (when alignment fails, just turn the

spiral pusher slightly).

Fit the larger-hole end of the juicer strainer into the tail of

the spiral pusher and push it while the three clips of the

juicer strainer align with the three clamping slots in the

juicing body. (The juice strainer is used with the juicing

button in the rear only. This function is used for juicing.)

DIRECTION FOR USE

Use of the appliance

Please install and use the appliance following the steps below.