User's Manual

-11-
compliance could void the user's authority to
operate the equipment.
 This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates uses and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
 —Reorient or relocate the receiving antenna.
 —Increase the separation between the
equipment and receiver.
 —Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
 —Consult the dealer or an experienced
radio/TV technician for help.
12.9 SAR tests are conducted using
 standard operating positions accepted by the
FCC with the Phone transmitting at its highest
certified power level in all tested frequency
bands, although the SAR is determined at the
highest certified power level, the actual SAR
level of the phone. While operating can be well
below the maximum value, in general, the closer
you are to a Wireless base station antenna, the
lower the power output. Before a new model
phone is a available for sale to the public, it
must be tested and certified to the FCC that it
does not exceed the exposure limit established
by the FCC, Tests for each phone are
performed in positions and locations (e.g. at the
ear and worn on the body)as required by the
FCC.
 For body worn operation, this model phone has
been tested and meets the FCC RF exposure.
Guidelines when used with an accessory
designated for this product or when used with
an accessory that Contains no metal and that
positions the handset a minimum of 1 cm from
the body.
 Non-compliance with the above restrictions may
result in violation of RF exposure guidelines.
