Instruction Manual

JT2020 Mach 1 Operator’s Manual Controls - 23
Set-Up Console
CMW
2. Cold start wait indicator Lights when intake air pre-
heater is operating.
Wait until light goes off before
starting engine.
3. Ignition switch To start engine, insert key and
turn clockwise.
To stop engine, turn key
counterclockwise.
IMPORTANT:
• Restart engine with ignition switch
after it has been turned off with
remote engine stop switch.
• If wrenches are engaged when
engine is stopped with ignition
switch, wrenches will release and
then engage when unit is started.
4. Left track switch To move forward, press top.
To move backward, press
bottom.
IMPORTANT: Use track switches only
if tethered control is inoperable.
5. Right track switch To move forward, press top.
To move backward, press
bottom.
IMPORTANT: Use track switches only
if tethered control is inoperable.
6. Right stabilizer control To raise, pull up.
To lower, push down.
IMPORTANT: Lower left and right
stabilizers to the ground to stabilize
unit and then adjust for side-to-side
stability. After unit is level, adjust for
entry angle.
NOTICE: Stand clear of stabilizer to
avoid crushing your foot.
Item Description Notes
c00ic147h.eps
c00ic148h.eps