Welder User Manual

Controls - 24 PR95 Operator’s Manual
Power Unit
CMW
Item Description Notes
1. Hourmeter Displays engine operating
time.
Gauge is marked “hours.”
Use these times to schedule service.
2. Main cylinders pressure
gauge
Displays hydraulic pressure
at main cylinders.
Gauge is marked “pump pressure
main.”
Full load reading should be 3600 psi
(248 bar).
3. Jaw system pressure
gauge
Displays hydraulic pressure in
jaw system.
Gauge is marked “pump pressure
jaws.”
Full load reading should be 3600 psi
(248 bar).
4. Battery charge
indicator
Lights when battery is not
charging.
Indicator is marked “charge.”
5. Engine preheater
indicator
Lights when glow plugs are
on.
Indicator is marked “glow.”
IMPORTANT: Start engine after light
goes off.
6. Engine oil pressure
indicator
Lights when engine oil
pressure is low.
Indicator is marked “oil pressure.”
7. Coolant temperature
indicator
Lights if cooling system fluid
overheats.
Indicator is marked “water temp.”
• Turn off engine and let cool.
• Check cooling system fluid level.