Operation Manual

DITEC Programming Instruction
www.mkey.com.au
This program is very simple when you have an existing remote
You should stand near your Didec motor or control box within 5 meters or between your gate and garage door(s).
Existing remote existing remote existing remote
Step 1. Press an existing remote make sure if the old remote works.
Step 2. Insert a paper clip or a needle into the underside tiny pore of your
existing remote 5 seconds (see the figure on back of the box)
New remote
Step 3. Press the button (with a dot) of your new remote 1 second.
Step 4. Wait for about 10 seconds.
The programming is done, now you can test your new remote if works
*****************************************************************
NOTICE: if your old remote is not working, please do the following procedures
2 3
Press the black program Press the button shown 1 second Wait for 10 seconds
button inside the control box(can
be opened by removing the cover)
for 5 seconds
*****************************************************************
How to delete existing code : for gate, press the little black program
button(open the motor box, it is inside) until seeing the red light flashing slowly
and release, and press the button again until seeing the light flashing really fast
and release, then wait for 10 seconds. DO the same thing to the gate and garage
door (the program button for garage should be on the receiver board)
Wait for 10 seconds