Installation Instructions

Doc # INT-100128-001
Part No. 191552 Rev. 2
INSTALL INSTRUCTIONS
DTK-1F
DITEK Technical Support Available 24/7
1-888-472-6100
www.ditekcorp.com
DITEK Corporation
ONE DITEK CENTER
1720 Starkey Road
Largo, FL 33771
INSTALLATION
This Surge Protection Device (SPD) is a high performance device, designed to provide protection
for sensitive electronic loads connected to service panels, fire panels, or where the SPD is
directly connected to the electronic device. Maximum protection will only be achieved if the SPD
is properly installed.
Please read and follow the installation instructions carefully.
NOTICE: This SPD should be installed by a licensed contractor in accordance with the National
and Local Electrical Codes and the following instructions.
APPLICATION
Surge suppression for indoor 120VAC circuits.
INSTRUCTIONS:
Caution: Measure all voltages to insure applied voltage does not exceed the voltage rating of
the unit. Improper installation voids the warranty.
1. Turn the main breaker off before beginning installation.
2.Remove the center screw from the receptacle face plate (Do not Remove the face plate)
3. Securely mount the DTK-1F to the receptacle using the supplied mounting screw.
4. Restore power to the circuit and make sure the LED is on indicating ground, power and
active surge protection.
5. Always have one common ground per system to eliminate the possibility of differential in
ground potentials.
Ground Resistance Rule: Max ground resistance is 25 Ohms, 5 Ohms or less is optimum.
This cannot be an assumed value and must be measured to assure proper grounding.
MOUNTING RECEPTACLE
SCREW INSERT
RECEPTACLE SCREW
Drawn By: B. Aycock 5-19-16
Approved By: R. Mitchell 7-5-16