Snore Stopper ASG 341 GB GB INSTRUCTION MANUAL • Snore stopper with electric stimulation current • 1 channel system with 2 adhesive electrodes on the inside of the device • Flexible wristband, individually adjustable up to 22 cm wrist size • Noise sensitivity from 65 dB (decibel) if background noises in the room are below 55 dB (decibel) • Contains: 1 snore stopper with adhesive electrodes, 2 spare adhesive electrodes, 3 alcoholic cleaning wipes, 1 instruction manual • 1 x 1.
GB TABLE OF CONTENTS No. Topic Page 1.0 Definition of symbols 4 2.0 Basic information 4 2.1 How does a snore stopper work? 4 2.2 Information about snoring 4 3.0 Safety instructions 5 3.1 General safety instructions 5 3.3 Usage/environment for which the snore stopper is suited 5 3.4 Usage/environment for which the snore stopper is not suited 6 3.5 Application for which the snore stopper is suited 6 3.6 Application for which the snore stopper is not suited 6 3.
TABLE OF CONTENTS No. Topic 12.0 Information regarding electromagnetic immunity GB Page 15 - 18 13.0 Technical specification, symbols, pictograms 19 14.0 Terms of warranty 20 Dear purchaser, Congratulations on your purchase of your new snore stopper ASG 341 and thank you for your trust. To ensure optimal functionality and operation of your snore stopper, please first read the instruction manual before using the device. This guarantees a long useful life of this product.
BASIC INFORMATION GB 1.0 Definition of symbols The safety symbols shown in this instruction manual contain information relating to the correct use of the snore stopper and your safety. The symbols refer to the following content: Read and follow the instruction manual. Warning/Danger: If not used correctly, serious or fatal injuries and damage may occur! The instructions must be followed at all times! Warning/Danger: The device must not be used by persons with a pacemaker! 2.0 Basic information 2.
SAFETY INSTRUCTIONS GB 3.0 Safety instructions 3.1 General safety instructions 3.1.1 The snore stopper may not be repaired, used or modified (changed) by the users themselves in case of a defect. If used incorrectly, the stimulation current may cause pain, injuries and burns. If, during the use of the snore stopper, skin alterations, pain, swellings, discomfort or other anomalies occur, you must stop the therapy immediately and seek medical advice.
GB SAFETY INSTRUCTIONS 3.4 Usage/environment for which the snore stopper is not suited 3.4.1 The snore stopper may not be used at the same time with other medical and electric devices of any kind. Do not use or wear the snore stopper while bathing, showering or in any other environment with high air humidity. Keep away from any liquids during use.
SAFETY INSTRUCTIONS 3.6.2 3.6.3 GB Please consult your doctor before using the snore stopper in the following circumstances: a. acute diseases, b. sleep disturbances, c. infectious diseases, d. fever, e. blood pressure problems, f. skin diseases, g. after an accident, h. nausea or dizziness, i. onset of illnesses, j. if anomalies occur, k. pain of inexplicable cause, l. diabetes, m. seizures, n. breathing pauses during sleep, o. if pain is not experienced in some parts of the body, p.
GB 3.9.0 4.0 4.0.1 4.0.2 4.0.3 SAFETY INSTRUCTIONS Avoid contact between the two electrodes. This will cause a short circuit, during which an increased current density flows. This increased current density may lead to burns and injuries. Where the adhesive electrodes must be attached The adhesive electrodes are attached to the inside of the device. Place the snore stopper against the outside of the wrist.
SCOPE OF DELIVERY/DISPOSAL 5.0 GB Scope of delivery/contents of packaging 1 snore stopper ASG 341 3 x adhesive electrodes 1 instruction manual 3 x alcoholic cleaning wipes 1 x 1.5 V battery AAA 6.0 Information about noise sources, noise scale up to 70 dB (decibel) 6.1 Noise sources and possible health effects: 0 dB: Hearing threshold of humans. 10 dB: Rushing of leaves, normal breathing of a human. 20 dB: Quiet garden, whispering, quiet room. 30 dB.
CHANGING THE BATTERIES GB 8.0 Changing the batteries and information about batteries 8.1 Place 1 battery (type AAA) in the device as shown in the figure. Observe the correct polarity (+ and – pole). Type of battery: Only use alkaline batteries for the snore stopper. Rechargeable batteries (batteries: NiMH, NiCd) may not be used. 8.2 Step 1: Open the wristband by pulling up the wristband holder on the housing (see image 1). Image 1 Image 2 8.3 8.4 8.5 8.6 8.7 8.8 8.
APPLICATION OF THE DEVICE GB 10.0 Application of the snore stopper Image Image 5 Step 1: Before attaching the adhesive electrodes, clean the two black electrode pads 5 with the enclosed alcoholic cleaning wipe (see image 5) or a commercially available alcoholic cleaning wipe. Step 2: Remove the blue protective foil from the adhesive electrodes as shown in image 6. This protective foil will not be needed for the further application.
DESIGNATION/FUNCTION 9.0 GB Designation and function of the snore stopper 6 Image 3 1 Image 4 2 4 3 5 1 Test button: Press the test button set intensity. 2 LED lamp: The green or red LED lamp 2 flashes when the device is switched on. If the red LED 2 flashes, there is no contact between the adhesive electrodes and the skin surface. The snore stopper is not ready for use. If the green LED 2 flashes, contact is made between the adhesive electrodes and the skin surface.
APPLICATION OF THE DEVICE GB Step 9: Switch on the device. Turn the on/off switch 3 to intensity level 2 (image 13). If skin contact is good, the green LED flashes once. If skin contact is not good, the red LED 2 flashes once (image 15). In this case, tighten the band a little and repeat step 9 until the green LED lights up. 2 Image 13 Image 14 Step 10: To test the strength of intensity, press the test button 1 three times in a row. The device activates an electric pulse for about 5 seconds.
TECHNICAL PROBLEMS GB 11.0 Technical problems, troubleshooting Fault The batteries are inserted, but there is no signal from the LED lamp. The green LED flashes, but the adhesive electrodes do not transmit any current pulses. Cause There could be foreign objects in the battery compartment. Ensure that the batteries are full and are inserted with the correct polarity. Check if the battery contacts make contact. Solution If foreign objects are present, they must be removed.
ELECTRIC IMMUNITY GB 12.0 Information regarding electromagnetic immunity Table 1 – Instruction and manufacturer's specifications – electromagnetic emissions – for all INSTALLATIONS and SYSTEMS (see 6.8.3.201 a) 3). Instruction and manufacturer's specifications – electromagnetic emissions The (INSTALLATION or the SYSTEM) is designed for the use in the electromagnetic environment described below.
ELECTRIC IMMUNITY GB 12.0 Information regarding electromagnetic immunity Guidelines and manufacturer's declaration – electromagnetic immunity The model ASG 341 is intended for operation in an electromagnetic environment as specified below. The customer or the user of the model ASG 341 should ensure that it is used in such an environment.
ELECTRIC IMMUNITY GB 12.0 Information regarding electromagnetic immunity Guidelines and manufacturer's declaration – electromagnetic immunity The model ASG 341 is intended for operation in an electromagnetic environment as specified below. The customer or the user of the model should ensure that it is used in such an environment.
ELECTRIC IMMUNITY GB 12.0 Information regarding electromagnetic immunity a. Theoretically, the field strength of stationary transmitters, such as base stations of wireless telephones and land mobile services, amateur radio stations, AM and FM radio and television stations, cannot be predicted precisely. An investigation of the site is recommended to determine the electromagnetic environment due to stationary HF transmitters.
TECHNICAL SPECIFICATION/SYMBOLS GB 13.0 Technical specification, symbols, pictograms Model type: Snore stopper ASG 341 Dimensions (LxWxH): Housing approx. 65 x 60 x 15 mm Weight: Approx. 45 g incl. weight of battery Adhesive electrode surface: 2 pieces with 20 x 24 mm (4.
TERMS OF WARRANTY GB 14.0 Terms of warranty The snore stopper ASG 341 has been developed and manufactured with great care. The statutory warranty period is 24 months as of the purchase date for material and manufacturing defects of the product. Please keep the receipt as proof of the purchase of the snore stopper ASG 341 in order to be able to assert a possible warranty claim.
