Operation Manual

Step 3:
Place the adhesive electrodes with the adhesive outside on
the two black rubber pads on the backside of the device,
so that the surfaces of the black pads and the adhesive
electrodes match (image 7).
Step 1:
Before attaching the adhesive electrodes, clean the two
black electrode pads with the enclosed alcoholic cleaning
wipe (see image 5) or a commercially available alcoholic
cleaning wipe.
12
Step 7:
Place the snore stopper about 3 cm away from the wrist and
press the snore stopper onto the arm (image 11). Insert the
wristband holder again und press down to lock it.
6
Step 6:
Open the two hook and loop fasteners on the outside of the
wristband and unfasten the band until the hook and loop
fastener reaches the wristband holder . Lift off the
wristband holder to unlock it from the housing (image 10).
6
6
Step 8:
Pull at the two ends of the wristband in order to adjust the
device to your lower arm (image 12). If necessary, change
the length of the wristband; if it sits too tightly, this could
impair the blood circulation.
Step 5:
Wait for 15 minutes after the application of the adhesive
electrodes, so that the adhesive layer can achieve optimal
adhesion. After this is done, the protective foil can be
removed (image 9).
Step 4:
Press the adhesive electrodes on the device with both
thumbs using a rotating movement to achieve a better
adhesion of the adhesive electrodes (image 8). Do not
remove the large protective foil!
Step 2:
Remove the blue protective foil from the adhesive electrodes
as shown in image 6. This protective foil will not be needed
for the further application.
APPLICATION OF THE DEVICE
10.0 Application of the snore stopper
Image 5
Image 7
Image 8
Image 9
Image 10
Image 12
Image 11
3 cm
Image 6
Image 5
Image 7
Image 8
Image 9
Image 10
Image 12
Image 11
3 cm
Image 6
Image 5
Image 7
Image 8
Image 9
Image 10
Image 12
Image 11
3 cm
Image 6
5
5
GB