Operation Manual

Wristband holder: The two wristband holders can be removed.
Black rubber pads: The adhesive electrodes are attached to the two black
electrode pads .
Battery compartment: By removing the battery compartment lid , the
battery (1 x 1.5 V AAA) can be replaced.
On/off switch: In position “0”, the device is switched off. By turning the on/off
switch , you can adjust the intensity in levels from 1 to 7.
LED lamp: The green or red LED lamp flashes when the device is switched on.
If the red LED flashes, there is no contact between the adhesive electrodes and
the skin surface. The snore stopper is not ready for use.
If the green LED flashes, contact is made between the adhesive electrodes and
the skin surface. The snore stopper is ready for use.
Test button: Press the test button a total of 3 consecutive times to test the
set intensity.
1
2
3
4
5
Image 3
Image 4
6
11
1
2
4
5
3
6
1
2
2
2
3
4
5
6
9.0 Designation and function of the snore stopper
DESIGNATION/FUNCTION
GB