Operation Manual

8
4.0.1
4.0.2
4.0.3
4.1.1
4.2.1
4.2.2
4.2.3
4.2.4
4.3.1
4.3.2
4.3.3
4.3.4
4.3.5
Do not immerse the snore stopper in water or other liquids.
A suitable, commercially available disinfectant may be used for disinfecting the
device. Let the snore stopper dry completely afterwards.
For hygienic reasons, every user should use his/her own adhesive electrodes.
Gently clean the surfaces of the snore stopper with a soft, damp cloth. Use water
to wet the cloth. Use a mild detergent in case of stubborn stains. Ensure that the
snore stopper has been switched off. Therefore, you must always remove the
batteries before cleaning the device. Let the snore stopper dry completely
afterwards. Do not use chemical detergents or abrasive cleaners to clean the
snore stopper or the adhesive electrodes.
The snore stopper must not be exposed to direct sunlight. Do not place the snore
stopper on hot surfaces.
4.3 Cleaning and care of the snore stopper
If the snore stopper ASG 341 is intended for trade or commercial use, a technical
safety inspection is necessary every 2 years in accordance with § 6 MPBetreibV
[German Medical Devices Operator Ordinance]. The technical safety inspection
must be carried out by a company specialised in medical devices. Further
information may be obtained from our service centre (see page 20).
If the device is not used for a prolonged period, remove the batteries from the
device.
Do not dismantle or repair the snore stopper; otherwise, technical or physical
accidents may occur – warning/mortal danger!
The snore stopper is maintenance-free.
4.2 Storage/maintenance of the snore stopper
The adhesive electrodes must not be attached to other parts of the body except
the outside of the respective wrist.
4.1 Where the adhesive electrodes must not be attached
The size of the adhesive electrodes must not be changed, e.g. by cutting off
pieces of the electrodes.
Do not use adhesive electrodes with an electrode size smaller than 20 x 25 mm
(4.8 cm²), as this could lead to the flowing of a too large current density, thereby
possibly causing injuries.
The adhesive electrodes are attached to the inside of the device. Place the snore
stopper against the outside of the wrist. This ensures that the adhesive electrodes
are also pressed against the skin surface on the outside of the wrist. Adjust the
wristband in order that the snore stopper is pressed against the wrist.
4.0 Where the adhesive electrodes must be attached
SAFETY INSTRUCTIONS
3.9.0 Avoid contact between the two electrodes. This will cause a short circuit, during
which an increased current density flows. This increased current density may lead
to burns and injuries.
GB