User guide

Using the NiTek3
36 NiTek3 Dive Computer User Manual
PC transfer mode
If you purchased the optional personal computer interface for the
NiTek3, you can transfer the stored dive log information to
your PC.
Before transferring the dive log
You must complete the following before transferring the dive
log.
• Install the NiTekLogic software onto your PC. Open the
program > click Options > and check the Uploader tab.
Make sure the COM port selection in the NiTekLogic
software matches the COM port you are connecting to.
• Plug one end of the cable supplied with the interface into a
COM port on your PC. Plug the other end into the interface
module.
• Set the NiTek3 to PC transfer mode as described below.
• Place the NiTek3 on the interface module and secure the
strap over the computer. Click the computer icon in
NiTekLogic. A dialog box should appear indicating the
beginning of data transfer. If it is not uploading, check your
COM port settings.
Notes
• If the dialog box says “negotiating” and cuts off before
saying “transfer,” you probably is a COM port setting issue.
Check to see that you are using the correct COM port.
• If there is an error reported after the dialog box says
“transfer,” check for a loose or dirty connection between the
NiTek3 and the interface module.