User guide

Using the NiTek X
41 NiTek X Dive Computer User Manual v1.1
PC Transfer Mode
You can transfer the stored dive log information to your personal
computer using the optional NiTek X WorkBench™ software
and the USB interface cable/dongle.
Before connecting the USB interface cable/dongle to your
computer, be sure to install the NiTek X WorkBench™ software
and drivers first.
To enter PC transfer mode:
1. Using the Battery Door Tool, remove the knurled cap at the
upper left of the NiTek X, and attach the USB interface
cable/dongle to the connector. Be sure to hold the computer
with its left side facing down to minimize any water droplets
from getting into the compartment.
2. Connect the other end of the cable to an internet-compatible
PC or Mac computer with NiTek X Workbench™, and start
the NiTek X Workbench™ program on the computer.
3. Repeatedly press button A on the NiTek X until “PC” is
displayed.
4. Press button B to enter the PC transfer mode screen.
“USB communicating” is displayed on the screen.
5. Transfer the dive log data to your PC.
6. When finished, press and hold button A for 2 to 3 seconds to
return to surface mode.
6. You may now access your NiTek X dive computer to
download your dives and make change to settings (such as
date/time, gas mixes, conservatism, alarms, etc).