User guide

Using the NiTek
32 NiTek Dive Computer User Manual
PC transfer mode
You can transfer the stored dive log information to your personal
computer using the optional NiTekLogic software and a PC
interface.
Before transferring the dive log
You must complete the following before transferring the dive
log.
• Install the NiTekLogic software onto your PC. Open the
program > click Options > and check the Uploader tab.
Make sure the COM port selection in the NiTekLogic
software matches the COM port you are connecting to on
your PC.
• Plug one end of the cable supplied with the interface into a
COM port on your PC. Plug the other end into the interface
module.
• Set the NiTek to PC transfer mode as described below.
• Place the NiTek on the interface module and secure the strap
over the computer. Click the computer icon in NiTekLogic.
A dialog box should appear indicating the beginning of data
transfer. If it is not uploading, check your COM port
settings.
Notes
• If the dialog box says “negotiating” and cuts off before
saying “transfer,” there is probably a COM port setting issue.
Check to see that you are using the correct COM port.