Owner`s manual

Battery Connection/Disconnection Procedure

WARNING: Sparks have the potential to cause an explosion should

combustible gases be present. The following procedures are designed to

minimise the risk of spark generation while connecting or disconnecting the

battery.

Battery Connection Procedure

The caravan battery should be connected as per the following steps.

1. Remove mains power to the Genius-II

Turn off the power switch on the Genius-II

2. Disconnect all loads

Turn off all 12 volt equipment connected to the Genius-II

3. Connect the positive battery terminal.

4. Connect the negative battery terminal.

If the battery negative is connected to chassis, ensure a connection exists from

chassis to the “Bat –VE” terminal of the Genius-II.

Battery Disconnection Procedure

The caravan battery should be disconnected as per the following steps.

1. Disconnect all loads

Turn off all 12 volt equipment connected to the Genius-II or disconnect the loads

using the remove load-disconnect switch.

2. Remove mains power to the Genius-II

Turn off the power switch on the Genius-II

3. Disconnect the negative battery.

4. Disconnect the positive battery terminal.

Batteries

Note: This battery charger is rated to charge a single 12 V (up to 6 cells) lead

acid battery of up to 100 Ah capacity. Charging current is limited to 15 A.

When using batteries with this product always consult with the battery

manufacturer for a detailed description of the installation, use and maintenance of

the battery.

Ensure the battery has been charged for several days before a major camping trip

(Leave the Genius-II power supply on for at least 2 days, preferably 5 days, with

battery connected.)