User's Guide
Table Of Contents
- General Safety
- Hardware
- Network Design
- Installation and Configuration
- Install Battery
- Configure Network
- VP Series 2000 Configuration Software
- Provision Devices
- Before you Begin
- Device Sleep State
- Provision Using a USB NFC Reader
- Provision Using a Divigraph ISA100 Gateway
- Provision Using a Yokogawa ISA100 Gateway
- Provision Using a Honeywell ISA 100 Gateway
- Provision using an Emerson WirelessHART Gateway
- Unprovision Devices
- Unprovision Using a USB NFC Reader
- Unprovision Using a Yokogawa ISA100 Gateway
- Unprovision Using a Honeywell ISA100 Gateway
- Reboot the Device
- Configure Devices
- System 1 Installation and Configuration
- Mount Devices
- Verification
- Maintenance
- Monitor Battery Levels
- Battery Status Monitoring
- Clean and Inspect Devices
- Update Device Firmware
- Update Radio Firmware
- Troubleshooting VP Series 2000 Devices
- Harden the System
EVR-VPXDOC-0036 VP Series 2000 User Guide
DIVIGRAPH
Rev 2.4.1
September 2021
Proprietary & Confidential – Copyright © 2020 Divigraph (Pty) Ltd. All Rights Reserved 7
System Components Required
To install, configure and use the VP Series 2000 wireless devices, you need:
• Lithium-thionyl chloride batteries, one per device. For approved battery types, see VP Series
Warnings, Special Conditions and Additional Information (DSDVP001).
• Battery installation tool.
• VP Series 2000 devices with batteries installed.
• Mounting hardware (plus adapters, if needed).
• A compatible USB NFC reader. Contact Divigraph for a list of compatible readers.
• VP Series 2000 Configuration Software (available from Divigraph).
• Spot facing tool, if required. (Not provided by Divigraph.)
• Torque wrench with ¼ inch drive, capable of tightening devices in the 5-7 Nm range (44 to 62 in-lb).
(Not provided by Divigraph.)
An installation kit is available from Divigraph. The installation kit can be ordered with or without a USB
NFC reader. Contact Divigraph for ordering information.
VP Series 2000 Components
The VP Series 2000 device consists of seven parts:
• Device case. Contains vibration and temperature sensors and forms the device's
housing (316 stainless steel body).
• Wireless e-module (glass-reinforced, impact-resistant PPS).
• Battery retaining ring (316 stainless steel).
• Two O-ring seals (35x1mm on the device case and 34x1mm on
e-module).
• Battery (replaceable D size 3.6V lithium-thionyl chloride). (Not provided by
Divigraph)
! NOTE
Use only approved D-sized lithium-thionyl chloride batteries for the VP Series
2000 devices. If you use the wrong battery, you can negatively affect device
performance, produce inaccurate readings, and void the warranty. You can
purchase approved batteries from third-party suppliers. For details, see VP Series
Warnings, Special Conditions and Additional Information (DSDVP001).