User's Guide
Table Of Contents
- General Safety
- Hardware
- Network Design
- Installation and Configuration
- Install Battery
- Configure Network
- VP Series 2000 Configuration Software
- Provision Devices
- Before you Begin
- Device Sleep State
- Provision Using a USB NFC Reader
- Provision Using a Divigraph ISA100 Gateway
- Provision Using a Yokogawa ISA100 Gateway
- Provision Using a Honeywell ISA 100 Gateway
- Provision using an Emerson WirelessHART Gateway
- Unprovision Devices
- Unprovision Using a USB NFC Reader
- Unprovision Using a Yokogawa ISA100 Gateway
- Unprovision Using a Honeywell ISA100 Gateway
- Reboot the Device
- Configure Devices
- System 1 Installation and Configuration
- Mount Devices
- Verification
- Maintenance
- Monitor Battery Levels
- Battery Status Monitoring
- Clean and Inspect Devices
- Update Device Firmware
- Update Radio Firmware
- Troubleshooting VP Series 2000 Devices
- Harden the System
EVR-VPXDOC-0036 VP Series 2000 User Guide
DIVIGRAPH
Rev 2.4.1
September 2021
Proprietary & Confidential – Copyright © 2020 Divigraph (Pty) Ltd. All Rights Reserved 14
3. Use the battery installation tool to remove the battery retaining ring.
Turn the ring counter-clockwise. Use the magnet in the tool to lift the
ring from the device case.
4. Inspect the O-rings on the e-module and case to verify they are present,
clean, and undamaged. Apply a very light coating of silicon-based O-ring
grease to the O-rings. (When replacing the battery, always replace the O-
rings.)
The Ranger Pro device uses two O-rings to seal the unit against dust and
moisture.
• 34x1mm O-ring on the e-module
• 35x1mm O-ring on the case
! NOTE
To maintain the device's IP67 dust and water-resistant rating and prevent leaks, you must install and
lubricate the O-rings properly.
5. Inspect the interior threads of the sensor case as well as the exterior threads of the battery retaining
ring to be sure they are not damaged or contaminated.
6. Verify that the positive end of the battery is up and then insert the
battery.
! NOTE
Use only approved D-sized lithium-thionyl chloride batteries for the
Ranger Pro sensors and repeaters. For ordering information, contact
Divigraph.
7. Use the battery installation tool to tighten the battery retaining ring.
Hand-tighten the ring until it contacts the battery, then torque to 5 N-m
(44 in-lb).