User's Guide
Table Of Contents
- General Safety
- Hardware
- Network Design
- Installation and Configuration
- Install Battery
- Configure Network
- VP Series 2000 Configuration Software
- Provision Devices
- Before you Begin
- Device Sleep State
- Provision Using a USB NFC Reader
- Provision Using a Divigraph ISA100 Gateway
- Provision Using a Yokogawa ISA100 Gateway
- Provision Using a Honeywell ISA 100 Gateway
- Provision using an Emerson WirelessHART Gateway
- Unprovision Devices
- Unprovision Using a USB NFC Reader
- Unprovision Using a Yokogawa ISA100 Gateway
- Unprovision Using a Honeywell ISA100 Gateway
- Reboot the Device
- Configure Devices
- System 1 Installation and Configuration
- Mount Devices
- Verification
- Maintenance
- Monitor Battery Levels
- Battery Status Monitoring
- Clean and Inspect Devices
- Update Device Firmware
- Update Radio Firmware
- Troubleshooting VP Series 2000 Devices
- Harden the System
EVR-VPXDOC-0036 VP Series 2000 User Guide
DIVIGRAPH
Rev 2.4.1
September 2021
Proprietary & Confidential – Copyright © 2020 Divigraph (Pty) Ltd. All Rights Reserved 18
WirelessHART Device Sleep State
The WirelessHART device radio listens for advertisements from the configured network for a one-hour
period at periodic intervals. This is followed by a one-hour deep sleep period, after which the device
reinitiates searching for the network as it did during the first hour. This cycle continues until it
successfully joins the network or is rebooted.
Provision Using a USB NFC Reader
To provision an individual VP Series 2000 device, use the VP Series 2000 configuration software and a
USB NFC reader. The software displays device details, including current provisioning and configuration,
sensor values, hardware model numbers, firmware version numbers, and enables you to perform
maintenance and diagnostics tasks.
To provision devices using the software and a USB NFC reader, you need:
• VP Series 2000 Configuration Software
• Supported USB NFC reader
• VP Series 2000 devices with batteries installed
• Network ID
• Join Key
• Radio (Device) Tag
Refer to your network vendor documentation for additional information regarding the Network ID and
Join Key allocation.
To provision sensors using the VP Series 2000 configuration software and a USB NFC reader:
1. Open the VP Series 2000 Configuration Software.
2. Select the “NFC Manager” tab.
3. Connect the USB NFC reader to the PC running the configuration software. If necessary, install any
drivers required. To obtain drivers, visit the website of the USB NFC reader vendor.
4. Select the appropriate USB NFC reader in the “NFC Manager” tab header.
5. Place the VP Series 2000 device upside down on the USB NFC reader pad.
6. Verify that the device has been successfully read by verifying that all fields have been updated and
the NFC status is “Ready” in the “NFC Manager” tab footer.
7. Select the “Configuration Manager > Live Configuration” tab and click on the “Provision” button.
8. Enter the “Network ID” and “Join Key”.
9. Click on “Provision Sensor”.
Provision Using a Divigraph ISA100 Gateway
The Divigraph NG1120 ISA100 gateway does not currently support OTA provisioning. Use the
configuration software and a USB NFC reader to provision VP Series 2000 devices using the network ID
and join key assigned for a Divigraph ISA100 gateway.