User's Guide

Table Of Contents

EVR-VPXDOC-0036 VP Series 2000 User Guide

DIVIGRAPH

Rev 2.4.1

September 2021

Unprovision Using a Yokogawa ISA100 Gateway

To unprovision VP Series 2000 devices using the Yokogawa “Field Wireless Management Console”:

1. In the Yokogawa “Field Wireless Management Console”, open “Monitor”.

2. Select “Tools > OTA Provisioning Manager”. The OTA Provisioning Manager dialog box is displayed.

3. Click the check box of one or more devices that you want to unprovision.

4. Click “Reset Provisioning Information” and then click “Apply”. the device is un-joined from the

network and reset to its original mode.

Unprovision Using a Honeywell ISA100 Gateway

To unprovision VP Series 2000 devices using the Honeywell OneWireless “Wireless Device Manager”:

1. Open the Honeywell OneWireless “Wireless Device Manager”.

2. Expand the “Selection Panel”.

3. Select one or more VP Series 2000 device(s).

4. In the tool bar, click “Channel > Inactivate”. The “Inactivate Channels” dialog box is displayed.

5. Select the device(s) you want to inactivate and click “Inactivate”. The device is inactivated and its

status is changed to out of service (OOS).

6. In the tool bar, click “Provisioning > Delete”. The Delete Devices dialog box is displayed.

7. Select the device(s) you previously inactivated.

8. Click “Delete”. The device is removed from the network. It is restarted and reset to its factory

defaults.

! Note

When you inactivate a devices' IO channels on a Honeywell gateway, the device IO channels remain

inactivated when the device is re-provisioned to the same or a different network. You must reactivate

the IO channels for data to publish from the sensor. Reactivate using the "activate" feature or by

manually setting the IO channel mode to "Auto".

Reboot the Device

If after several hours the device fails to join the network, reboot the device. Remove the device from the

field and reboot it in an equipment room or similar environment.

To reboot a single device using the configuration software and a USB NFC reader:

1. Open the Ranger Pro configuration software

2. Connect the USB NFC reader to the computer running the configuration software.

3. Place the VP Series 2000 device upside down on the NFC reader pad.

4. Select the “NFC Manager” tab.

5. Verify that the senor has been successfully read by checking that all fields have been updated and

the NFC status is “Ready” in the tab footer.

6. Expand “Maintenance > Power Control”.

7. Click “Reboot” to restart the device.