User's Guide
Table Of Contents
- General Safety
- Hardware
- Network Design
- Installation and Configuration
- Install Battery
- Configure Network
- VP Series 2000 Configuration Software
- Provision Devices
- Before you Begin
- Device Sleep State
- Provision Using a USB NFC Reader
- Provision Using a Divigraph ISA100 Gateway
- Provision Using a Yokogawa ISA100 Gateway
- Provision Using a Honeywell ISA 100 Gateway
- Provision using an Emerson WirelessHART Gateway
- Unprovision Devices
- Unprovision Using a USB NFC Reader
- Unprovision Using a Yokogawa ISA100 Gateway
- Unprovision Using a Honeywell ISA100 Gateway
- Reboot the Device
- Configure Devices
- System 1 Installation and Configuration
- Mount Devices
- Verification
- Maintenance
- Monitor Battery Levels
- Battery Status Monitoring
- Clean and Inspect Devices
- Update Device Firmware
- Update Radio Firmware
- Troubleshooting VP Series 2000 Devices
- Harden the System
EVR-VPXDOC-0036 VP Series 2000 User Guide
DIVIGRAPH
Rev 2.4.1
September 2021
Proprietary & Confidential – Copyright © 2020 Divigraph (Pty) Ltd. All Rights Reserved 25
Configure Devices
Use the configuration software to configure sensor data. You can save configuration settings as a file to
your hard drive, share the settings file locally and remotely, and apply the saved settings to multiple
sensors over the network.
Configuration files include:
• Configuration version
• Identification information
• Acquisition timing and scheduling settings
• Temperature measurement settings
• Vibration measurement settings
You can configure VP Series 2000 devices using either:
NFC Manager
(Using NFC)
Configure VP Series 2000 devices one at a time at your desk or in a
safe area.
Network Manager (Over
the air Configuration)
Configure one or many sensors over the network using VP Series
2000 Configuration Software.
You can use the
VP Series 2000 configuration software to define sensor settings using either:
Live Configuration
View, modify and update sensor configurations in real-time. Most
often used to change device configuration on a single device.
Preset Configuration
View, modify, save, and apply saved or default settings to multiple
sensors over the network. Most often used with customer defined
configuration templates.