User's Guide
Table Of Contents
- General Safety
- Hardware
- Network Design
- Installation and Configuration
- Install Battery
- Configure Network
- VP Series 2000 Configuration Software
- Provision Devices
- Before you Begin
- Device Sleep State
- Provision Using a USB NFC Reader
- Provision Using a Divigraph ISA100 Gateway
- Provision Using a Yokogawa ISA100 Gateway
- Provision Using a Honeywell ISA 100 Gateway
- Provision using an Emerson WirelessHART Gateway
- Unprovision Devices
- Unprovision Using a USB NFC Reader
- Unprovision Using a Yokogawa ISA100 Gateway
- Unprovision Using a Honeywell ISA100 Gateway
- Reboot the Device
- Configure Devices
- System 1 Installation and Configuration
- Mount Devices
- Verification
- Maintenance
- Monitor Battery Levels
- Battery Status Monitoring
- Clean and Inspect Devices
- Update Device Firmware
- Update Radio Firmware
- Troubleshooting VP Series 2000 Devices
- Harden the System
EVR-VPXDOC-0036 VP Series 2000 User Guide
DIVIGRAPH
Rev 2.4.1
September 2021
Proprietary & Confidential – Copyright © 2020 Divigraph (Pty) Ltd. All Rights Reserved 53
Update Radio Firmware
Radio firmware is rarely modified and if needed the radio firmware files can be requested from
Divigraph technical support to update the radio firmware.
Updating of WirelessHART radio firmware is not supported.
VP Series 2000 ISA100 device radio firmware can be updated over-the-air by supported wireless
network infrastructure gateways.
Update Radio Firmware Using a Divigraph ISA100 Gateway
To update the radio firmware using the Divigraph ISA100 gateway web interface:
1. Verify that all VP Series 2000 devices are provisioned, connected to the network, and joined to the
gateway.
2. In the gateway web interface, select the "Firmware" menu item.
3. Upload the required firmware by clicking on the "Upload" button on the "Firmware" tab:
a. Click on "Browse" to navigate to and select the relevant radio firmware file.
b. Select the "Firmware Type" to be uploaded as "Radio".
c. Enter the firmware "Version" number and provide a short "Description".
d. Click on "OK" to upload the firmware.
4. Select the "Devices to Upgrade" tab and select "Radio" as the firmware type to update.
5. Select the devices to which the firmware update must be applied and select "Execute".
6. Monitor the update on the "Progress" tab.
Update Radio Firmware Using a Yokogawa ISA100 Gateway
With one exception, the process to upgrade VP Series 2000 device radio firmware on a Yokogawa
gateway is the same as upgrading the sensor firmware. In the “Firmware Download Manager” dialog
box, select the “Radio Firmware” tab. Otherwise the steps are entirely the same. Refer to the “Update
Device Firmware Using a Yokogawa ISA100 Gateway” section for details.
Update Radio Firmware Using a Honeywell ISA100 Gateway
With one exception, the process to upgrade VP Series 2000 device radio firmware on a Honeywell
gateway is the same as upgrading the sensor firmware. In the tools ribbon, choose “Radio”. Otherwise
the steps are entirely the same. Refer to the “Update Device Firmware Using a Honeywell ISA100
Gateway” section for details.