Technical data

Ichill 200CX EVO rev 1.1 14/11/2013
Pag. 11 of 151
If the Ichill is used to control a condensing unit (CF03=1):
• and a digital input has to be configured as “regulation request”; in case of cooling request by key
the display shows “OnC”; in STD-BY the display swows “On”, when the digital input is not active
the display shows “OFF”
• and a digital input has to be configured as “regulation request”; in case of heating request by key
the display shows “OnH”; in STD-BY the display swows “On”, when the digital input is not active
the display shows “OFF”
3.1 DISPLAY VISUALIZATION IN REMOTE OFF
Digital input configured as remote ON/OFF: the active input sets the unit in OFF (even when the unit is a
condensing unit).
The upper display shows “OF.F ”, the led of the decimal point is blinking.
3.2 DISPLAY VISUALIZATION IN STD-BY
It is possible to customise the visualization of the display when the unit is in STD-BY:
Parameter dP10:
0= the display shows "STD-BY"
1= the display shows what defined by parameters dP1 and dP2
2= the display shows “OFF”
dP10=0
dP10=1
The display shows what defined by parameters dP1 and dP2
dP10=2