Product Manual

17
700375 08/2013
Dixie Chopper ▪ 6302 E. County Road 100 N. ▪ Coatesville, IN ▪ 46121 ▪ www.dixiechopper.com
Basic Mower Adjustments, Maintenance, and Repair
Replace the drive belts if they show signs of cuts,
tears, burns caused by slipping, or excessive wear.
Refer to the Routine Maintenance section of this
manual for a schedule of replacement.
1. Loosen the tension on the vertical/ horizon
tal idler pulley by pulling it away from belt.
2. Remove belt from pulley noting the routing of
belt.
3. Install new belt onto pulley, routing it in the
same con guration as the replaced belt.
The pulley can be moved as needed.
See belt routing on page 19.
Drive Belt Replacement
AU O
Never attempt to make any
adjustments to mower deck or
work under it while mower is
running. Make sure that ignition switch is off and
key removed, PTO switch is disengaged, steer-
ing speed control levers are in neutral lock, and
parking brake is on. Failure to comply will result in
personal injury or death.
Deck Drive Belt Tension (Non-Adjustable)
Engine to Deck
Idler Arm
Hour Meter
Functions:
1. Tachometer
2. Engine Hours
3. System Voltage
4. Initial Oil Change (Break in oil)
5. Scheduled Oil Service Alert
6. Air  lter service Alert
7. Fuel  lter service Alert
Operation:
Push and release mode button to toggle between
functions, the mode button will also be used to clear
alerts and/or timers.
The service alert timer counts down from a set
interval,when the hour meter reaches the GENTLE
ALERT INTERVAL for a qualifying function your meter
will begin to  ash messages such as CHG OIL, SVC
AIR FILTER and SVC FUEL FILTER. As the interval
countdown continues and 0 hours remain for service
intervals messages such as CHG OIL NOW, SVC
AIR FILTER NOW, SVC FUEL FILTER NOW will be
displayed.
Reset Procedure:
Select the alert or timer you would like to reset press
and HOLD the mode button for 3 to 7 seconds (an
alert or timer reset can be performed at any time).
Mode Button