Specifications

100 Ton Ram Instruction Manual
Specifications 3 Section 1
• F-N-R (Forward-Neutral-Reverse) directional control lever.
The F-N-R lever (shown in the neutral position) controls the
direction of the ram cylinder. To extend the cylinder (forward) in the
direction of the die bed, move the lever toward the pump motor then
activate the pump. To retract the cylinder (reverse), move the lever
away from the pump motor then activate the pump.
• On-Off-Remote switch, 0 - 10,000 psi pressure gage and hand held
remote.
When the toggle switch is placed in the “On” position, the pump
motor will run until the toggle switch is placed in the “Off” position.
When the toggle switch is placed in the “Remote” position, the hand
held remote is activated. To run the pump motor, depress and hold
the switch on the remote. To stop the motor, release the switch on
the remote. For practical purposes, leave the toggle switch in the
“Remote” position. All future references to activating the pump motor
should be understood that the hand held remote is being used.
Caution! Never dead-end the cylinder (fully extended or fully retracted) and leave it with pressure showing on
the gage. If the cylinder is dead-ended, always move the lever to the neutral position after stopping the pump.
Failure to do so can shorten the life of the cylinder seals.
Operating Controls