Product specifications

Page 6 of 14
SECTION 3 - OPERATOR CAUTIONS
1. When changing a bit, make certain the Forward / Reverse switch is in
the "OFF" position and the tool is unplugged.
2. Do not allow chemicals such as acetone, benzene, thinner,
trichloroethylene, ketone, or other similar chemicals to come in contact
with the screwdriver housing or damage will result.
3. Do not drop or abuse the screwdriver.
4. Do not adjust the torque setting higher than 8 on the torque scale.
5. There should be a tool rest interval of three seconds or longer. This tool
is intended for a cycle of 0.8 sec on, 3.2 sec off. Do not tighten more than
15 pieces per minute. Do not allow the motor to overload or overheat.
6. Do not tighten more than 900 self-tapping screws per hour.
7. Do not switch from Forward to Reverse while the motor is running.
8. Be sure the Forward / Reverse switch is in the "OFF" position before
connecting or disconnecting the screwdriver plug.
9. Whenever the tool is not being used or when changing accessories,
move the Forward / Reverse Switch to the "OFF" position and unplug the
screwdriver.
WARNING
Do not drop or abuse the tool.
Whenever a tool is not being used,
set the Power Switch to the "OFF"
position and unplug the power cord.