User manual
Table Of Contents
- Disclaimer
- About
- Contents
- Cautions
- Legend
- In The Box
- Mounting the Landing Gear
- Mounting Frame Arms
- Mounting Electronics and Wiring
- Connecting XT60 Ports on the Center Frame
- Installing Battery
- Setting Up the Landing Gear
- Mounting the Gimbal
- Appendix
- FAQ
- Part List
- The FCC Certification Requirements
- Disclaimer
- About
- Cautions
- Legend
- In The Box
- Mounting the Landing Gear
- Mounting Frame Arms
- Mounting Electronics and Wiring
- Connecting XT60 Ports on the Center Frame
- Installing Battery
- Setting Up the Landing Gear
- Mounting the Gimbal
- Appendix
- FAQ
- Part List
- FCC Statements
Spreading Wings S1000
+
User Manual
10
©
2014 DJI. All Rights Reserved.
12. Replace the round cover of the center plate, and re-tighten the 4 screws (M3x8 self-tapping). Then
replace the upper plate of the center frame, and re-tighten the 8 screws (M2.5x8 cheese).
13. Double check all frame arms. Arms M1 and M2 are the forward facing (nose), arms M5 and M6 are the
tail. Seen from the top, motors on arms M1, M3, M5 and M7 rotate counter clockwise while those on arms
M2, M4, M6 and M8 rotate clockwise.