User manual
Table Of Contents
- Disclaimer
- About
- Contents
- Cautions
- Legend
- In The Box
- Mounting the Landing Gear
- Mounting Frame Arms
- Mounting Electronics and Wiring
- Connecting XT60 Ports on the Center Frame
- Installing Battery
- Setting Up the Landing Gear
- Mounting the Gimbal
- Appendix
- FAQ
- Part List
- The FCC Certification Requirements
- Disclaimer
- About
- Cautions
- Legend
- In The Box
- Mounting the Landing Gear
- Mounting Frame Arms
- Mounting Electronics and Wiring
- Connecting XT60 Ports on the Center Frame
- Installing Battery
- Setting Up the Landing Gear
- Mounting the Gimbal
- Appendix
- FAQ
- Part List
- FCC Statements
20
©
2014 DJI. All Rights Reserved.
Mounting the Gimbal
Before assembling the gimbal, install the GCU as shown below. Be sure to install on the side as shown below.
A DJI Z15-5D MARK III (HD) gimbal has been used as an example in the following diagrams.
The connectors on gimbal should be removed for better performance, then the gimbal can be mounted to the
lower connection points.
Mounting the Gimbal