User manual
Table Of Contents
- Disclaimer
- About
- Contents
- Cautions
- Legend
- In The Box
- Mounting the Landing Gear
- Mounting Frame Arms
- Mounting Electronics and Wiring
- Connecting XT60 Ports on the Center Frame
- Installing Battery
- Setting Up the Landing Gear
- Mounting the Gimbal
- Appendix
- FAQ
- Part List
- The FCC Certification Requirements
- Disclaimer
- About
- Cautions
- Legend
- In The Box
- Mounting the Landing Gear
- Mounting Frame Arms
- Mounting Electronics and Wiring
- Connecting XT60 Ports on the Center Frame
- Installing Battery
- Setting Up the Landing Gear
- Mounting the Gimbal
- Appendix
- FAQ
- Part List
- FCC Statements
24
©
2014 DJI. All Rights Reserved.
Remounting the Propellers
Instructions
1. Use two M3x12.3 screws and four washers to remount propellers.
2. Apply thread locker to the thread of the propellers mount rst.
3. Afx screws with 3Kg ∙ cm (0.3N ∙ m) torque.
Refer to original screw tensions if you are unfamiliar with torque measurements. Applying thread
locker to the propeller mount rst avoids getting thread locker into the holes of the plastic propeller.
Loose screws cannot be securely locked with thread locker.
G V
G P
G V
G P
Red
Black
Blue
Thick wire
Solder pad
Blue
Black
Red
Fine wire
Fine wire
Thick wire
CCW arms CW arms
Propeller Precautions
Torque markers on the screws and propeller covers will give you a visual cue to check whether the propellers
are loose. Check the torque markers before every ight.
FAQ
Soldering the ESC
Be sure to solder the thick wires and ne wires correctly when soldering an ESC to the frame arm.
Clockwise (CW) and counter clockwise (CCW) motors have a different arrangement of the colored wires.
FAQ