User manual
Table Of Contents
- Disclaimer
- About
- Contents
- Cautions
- Legend
- In The Box
- Mounting the Landing Gear
- Mounting Frame Arms
- Mounting Electronics and Wiring
- Connecting XT60 Ports on the Center Frame
- Installing Battery
- Setting Up the Landing Gear
- Mounting the Gimbal
- Appendix
- FAQ
- Part List
- The FCC Certification Requirements
- Disclaimer
- About
- Cautions
- Legend
- In The Box
- Mounting the Landing Gear
- Mounting Frame Arms
- Mounting Electronics and Wiring
- Connecting XT60 Ports on the Center Frame
- Installing Battery
- Setting Up the Landing Gear
- Mounting the Gimbal
- Appendix
- FAQ
- Part List
- FCC Statements
Spreading Wings S1000
+
User Manual
©
2014 DJI. All Rights Reserved.
25
Using the Propeller Holder
Instructions
1. Insert the propeller blades into the propeller holder. 2. Attach the propeller holder to the frame arm.
Assembling Motor Vibration Absorbers
A soft gasket is part of the vibration absorber. Assemble soft gaskets as shown below. Assembly is the same
for CCW and CW propellers.
Before installing the soft gaskets, put the copper rings onto the four mounting holes on the carbon
plate. Then put the soft gaskets into the mounting holes.
After tightening the screws, the vibration absorbers may be twisted. If this is the case, hold the
motor with your thumbs under the base plate and ngers on the top carbon plate, and squeeze the
plates together to make the vibration absorbers at and parallel with the plates.
FAQ