User manual
Table Of Contents
- Disclaimer
- About
- Contents
- Cautions
- Legend
- In The Box
- Mounting the Landing Gear
- Mounting Frame Arms
- Mounting Electronics and Wiring
- Connecting XT60 Ports on the Center Frame
- Installing Battery
- Setting Up the Landing Gear
- Mounting the Gimbal
- Appendix
- FAQ
- Part List
- The FCC Certification Requirements
- Disclaimer
- About
- Cautions
- Legend
- In The Box
- Mounting the Landing Gear
- Mounting Frame Arms
- Mounting Electronics and Wiring
- Connecting XT60 Ports on the Center Frame
- Installing Battery
- Setting Up the Landing Gear
- Mounting the Gimbal
- Appendix
- FAQ
- Part List
- FCC Statements
©
2014 DJI. All Rights Reserved.
5
In The Box
Center Frame ×1 Frame Arms ×6
Landing Skid Tubes ×2
(with Silicone Rubber Dampers)
Landing Gear Legs ×2
GPS Collapsible Mount ×1 Springs ×2
Connector Set ×1 Accessories Package ×1
CW propellers ×2
CCW propellers ×2
Magic tapes ×4
The red knobs ×8
Soft vibration absorbing gaskets ×50
Screw Package ×1
For frame arms mount: M4×35
For landing gear mount: M3×8, M2.5×8 (socket cap), M3×22 (socket cap)
Tools Required
Tools Usage
2.0mm Hex Wrench, 2.5mm Hex Wrench Mounting screws.
Thread Locker Fastening screws.
Nylon Cable Tie
Binding devices and wires.Scissors
Cutting Pliers/Dykes
Foam Double Sided Adhesive Tape Mounting receiver, controller and other modules.
In The Box