User manual
Table Of Contents
- Disclaimer
- About
- Contents
- Cautions
- Legend
- In The Box
- Mounting the Landing Gear
- Mounting Frame Arms
- Mounting Electronics and Wiring
- Connecting XT60 Ports on the Center Frame
- Installing Battery
- Setting Up the Landing Gear
- Mounting the Gimbal
- Appendix
- FAQ
- Part List
- The FCC Certification Requirements
- Disclaimer
- About
- Cautions
- Legend
- In The Box
- Mounting the Landing Gear
- Mounting Frame Arms
- Mounting Electronics and Wiring
- Connecting XT60 Ports on the Center Frame
- Installing Battery
- Setting Up the Landing Gear
- Mounting the Gimbal
- Appendix
- FAQ
- Part List
- FCC Statements
6
©
2014 DJI. All Rights Reserved.
Mounting the Landing Gear
Instructions
1. Insert one landing gear leg into each landing skid tube and secure it in place by tightening the M2.5x8
(socket cap) screw. Ensure silicone rubber dampers are attached to each end.
2. Insert the landing gear leg into connection point on the center frame. Afx in place with M3x8 screws.
3. Connect both springs on the legs to the center frame.
Note the springs are 58.5mm before connecting to the center frame, and are stretched to 70mm
when mounting is completed.
Mounting the Landing Gear
M2.5x8
(socket cap)
70mm