User manual
Table Of Contents
- Disclaimer
- About
- Contents
- Cautions
- Legend
- In The Box
- Mounting the Landing Gear
- Mounting Frame Arms
- Mounting Electronics and Wiring
- Connecting XT60 Ports on the Center Frame
- Installing Battery
- Setting Up the Landing Gear
- Mounting the Gimbal
- Appendix
- FAQ
- Part List
- The FCC Certification Requirements
- Disclaimer
- About
- Cautions
- Legend
- In The Box
- Mounting the Landing Gear
- Mounting Frame Arms
- Mounting Electronics and Wiring
- Connecting XT60 Ports on the Center Frame
- Installing Battery
- Setting Up the Landing Gear
- Mounting the Gimbal
- Appendix
- FAQ
- Part List
- FCC Statements
Spreading Wings S1000
+
User Manual
8
©
2014 DJI. All Rights Reserved.
5. Gently lift the frame arm.
6. Twist the red knob to lock each arm in place. Be sure there is an audible click, which indicates a proper
lock. Check the arm for movement. To store, untwist the knob and lower the frame arm.
7. Now unscrew 8 screws (M2.5x8 cheese) on the upper plate of the center frame and remove the upper
plate. Then unscrew the 4 screws (M3x8 self-tapping, found under the center frame) of the round cover
and remove it to gain access to the ESC and power cable installation area.
8. Plug each ESC signal cable into the slot near each arm on the center frame.
Mounting Frame Arms