Owner's Manual

IV. Function Description
1. Turn on and connect the controller
1) Short press the button to turn on, if it starts successfully, the ABXY
button of the controller will be always on.
2) Power display LED flickers slowly; Enter the Bluetooth mode directly
to wait for the APP connection;
3) Enter the flight control APP to connect the controller;
4) After connecting, the power display LED is always on and show the
quantity of electricity.
5) If the controller has been connected to other phones, press the "Pair"
button of the controller to force the controller to enter the state of waiting
match.
2. Turn-off
1) Long press the power button for 3-5 seconds, shut down the
controller, turn off all the LED lights;
3. Automatic turn-off
1) The controller is in connecting state, if it is idle for more than 5
minutes, the controller will turn off automatically.
2) The controller is in disconnecting state (waiting for connection), if no
connection for 2 minutes, the controller will turn off automatically.
4. Check the power
After the controller connected successfully, the LED lamp will show
current power information.
The LED lamp group shows the proportion: Fully bright is about 75% to
100%; 3 lights are about 50% to 75%; 2 lights are about 25% to 50%; 1
light is about 1% to 25%
5. Low battery alarm
1. When the available power is lower than the low power alarm voltage,
the LED light group lasts double flash;
2. When the available power is lower than the battery protection voltage,
the controller will turn off automatically.
6. Battery charging
1) LED lights 1-4 flicker slowly during charging;
2) When the charge is over (full), the LED light group is always on;
Disconnect the charging cable after charging.