User manual
Table Of Contents
©
2021 DJI All Rights Reserved.
41
AGRAS T10
User Manual
In Multi Linking mode, firmware updates and logs are unavailable for aircraft and other
devices except for the remote controller.
There is a short delay when switching between Single and Multi Linking. Device information in
the Linked Aircraft list will be cleared automatically after the switch.
Exiting Multi-Aircraft Control Mode
Users can exit from the mode using one of the following three methods.
Method 1: Link the remote controller to a single aircraft. Refer to the Linking the Remote Controller
section and follow the instructions for single linking.
Method 2: In the Linked Aircraft list, delete other aircraft and leave a single aircraft. The remote controller
will only control this aircraft and can operate using the other operation modes.
Method 3: Power off the aircraft that are not required leaving a single aircraft powered on. The remote
controller will only control this aircraft and can operate using the other operation modes. Notes: If the
other aircraft are powered on again, the remote controller and the linked aircraft will enter Multi-Aircraft
Control mode automatically. Use Method 1 or 2 to exit Multi-Aircraft Control mode completely.