User manual
Table Of Contents
54
©
2021 DJI All Rights Reserved.
DJI Assistant 2 for MG
Configure settings of the basic parameters, copy flight records, and update aircraft and remote
controller rmware in DJI Assistant 2 for MG.
Installation and Launching
1. Download the DJI Assistant 2 for MG installation le from the T10 download page:
https://www.dji.com/t10/downloads
2. Install the software.
3. Launch DJI Assistant 2 for MG.
Using DJI Assistant 2 for MG
Connecting the Aircraft
Connect the USB-C port on the bottom of the aircraft to a computer with a USB-C cable, and then power
on the aircraft.
Make sure to remove the propellers before using DJI Assistant 2 for MG.
Remove the waterproof cover on the USB-C port before use. Attach the waterproof cover to the
port after use. Otherwise, water may enter the port, causing it to short circuit.
Firmware Update
A DJI account is required for rmware updates. Login or register an account.
Exporting Log
View all the logs of the aircraft and select logs to export.
Simulator
Click Open to enter the flight simulation view. Input location and environment parameters and click
Congure to save. Click Start Simulation to enter ight simulation practice.
Basic Settings
Congure the idle speed of and test the motor.
Connecting the Remote Controller
1. Connect the USB-C port of t he remote controller to a computer with a USB A to A cable, and then
power on the remote controller.
2. Swipe from the top of the screen, and make sure that the USB option is enabled.
Firmware Update
A DJI account is required for rmware updates. Login or register an account.
Exporting Log
View all the logs of the remote controller and select the logs to export.
DO NOT power off the remote controller during the update.
DO NOT perform the rmware update while the aircraft is in the air. Only carry out the rmware
update when the aircraft is on the ground.
The remote controller may become unlinked from the aircraft after the rmware update. Relink
the remote controller and aircraft if necessary.