User manual
Table Of Contents
DJI Avata
User Manual
84
© 2022 DJI All Rights Reserved.
FAR Remote ID Compliance Information
The aircraft complies with the requirements of 14 CFR Part 89:
The aircraft automatically broadcasts Remote ID messages from takeo to shut down. An external device
such as a cell phone or tablet is required to be connected as a location source to DJI mobile devices without
an integrated GNSS system
[1]
, and must run the DJI ight control app such as DJI Fly in the foreground and
always allow the DJI ight control app to obtain its accurate location information. The connected external
device must minimally be one of the following:
1) FCC Certied personal wireless device that uses GPS with SBAS (WAAS) for location services; or
2) FCC Certied personal wireless device with integrated GNSS.
Also, the external device must be operated in a way that does not interfere with the location reported and its
correlation to the operator location.
The aircraft automatically initiates a pre-ight self-test (PFST) of the Remote ID system before takeo and
cannot take o if it does not pass the PFST
[2]
. The results of the PFST of the Remote ID system can be
viewed in either a DJI ight control app such as DJI Fly or DJI goggles.
The aircraft monitors the Remote ID system functionality from pre-ight to shut down. If the Remote ID system
malfunctions or has a failure, an alarm will be displayed in either a DJI ight control app such as DJI Fly or DJI
goggles.
Footnotes
[1] DJI mobile devices without an integrated GNSS system such as DJI RC-N1, DJI FPV Goggles V2, and DJI
Goggles 2.
[2] The pass criterion for PFST is that the hardware and software of the Remote ID required-data source and
transmitter radio in the Remote ID system are functioning properly.