User Manual

INSPIRE 2

User Manual

[1]

[2]

[4]

[3]

Vision System and Infrared Sensing System

The main components of the Vision System are located on the front and bottom of the Inspire 2,

including [1] [2] two stereo vision sensors and [3] two ultrasonic sensors. The Vision Sys tem uses

ultrasound and image data to help the aircraft maintain its current position, enabling precision hov-

ering indoors or in environments where a GPS signal is not available. The Vision System constantly

scans for obstacles, allowing the Inspire 2 to avoid them by going over, around, or hovering.

The Infrared Sensing System consists [4] of two infrared modules on top side of the aircraft. These

scan for obstacles on top side of the aircraft and is active in certain ight modes.

You can drag on a subject in the DJI GO 4 app or move the gimbal control sticks to

change the subject's position in the shot.

Aircraft auto spin is enabled by default in Free Mode. It spins the aircraft in the opposite

angle to gimbal rotation to avoid rotation limits during shooting.

Spotlight Pro can be used in S-Mode, A-Mode, TapFly Mode and Tripod Mode.

Detection Range

The detection range of the Vision System is depicted as follow. Note that the aircraft cannot sense

and avoid the obstacles that are not within the detection range.

40cm

60cm