User Manual

32
©
2019 DJI All Rights Reserved.
MATRICE 200 SERIES V2 User Manual
DJI AirSense
Airplanes and helicopters with an ADS-B transceiver will actively broadcast flight information
including location, ight path, speed, and altitude. DJI AirSense receives this by ADS-B transceivers
via an on-board receiver or internet connection. UAVs installed DJI AirSense can obtain the position,
orientation and velocity information from the manned airplane built-in ADS-B transmitter (1090 ES
and UAT standard supported), calculate the collision risk level real time and send the warning to
user. The system will analyze the potential risk of collision by comparing the location of an airplane
or a helicopter, sending timely warnings to pilots via the DJI Pilot app.
DJI AirSense provides users with information about nearby airplanes and helicopters to ensure ight
safety. The system doesn’t actively control the drone to avoid incoming airplanes or helicopters.
Always y your aircraft within a visual line of sight and be cautious at all times. Lower your altitude
when you receive warnings. Please be aware that DJI AirSense has the following limitations:
1. It can only receive messages sent by airplanes and helicopters installed with an ADS-B out
device and in accordance with 1090ES (RTCA DO-260) or UAT (RTCA Do-282) standards.
DJI devices will not receive related broadcast messages or send out warnings for airplanes or
helicopters without ADS-B outs or with malfunctioning ADS-B outs.
2. If there is an obstacle or steel structure between airplanes or helicopters and DJI aircraft, the
system won’t be able to receive ADS-B messages sent by airplanes or helicopters or send out
warnings. Keenly observe your surroundings and y with caution.
3. Warnings may be sent with delay when the DJI AirSense is interfered by the surrounding. Keenly
observe your surroundings and y with caution.
4. Warnings are not sent when a DJI aircraft is unable to determine its location.
5. It cannot receive ADS-B messages sent by airplanes or helicopters or send out warnings when
disabled or miscongured.
On the precondition that connection between a DJI aircraft and the pilot remote controller is stable,
when the system conrms the possibility of a collision, it will send a series of warnings based on the
distance between drone and airplanes or helicopters. We recommended that the operator descend
altitude immediately after the rst warning to avoid a collision, choosing another ight path where
necessary.
Warning Escalation:
The rst (or "lowest") level warning occurs three minutes away from the airplanes or helicopters.
The second (or “middle”) level warning occurs two minutes away from the airplanes or helicopters.
The third (or “highest”) level warning occurs one minute away from the airplanes or helicopters.
Red: The third level warningBlue: The rst level warning Yellow: The second level warning