Mavic 3 Enterprise - User Manual v1.0

Table Of Contents

DJI Mavic 3E/3T User Manual

obstacles, buildings, or trees nearby and that the aircraft is 5 m away from the pilot. The

pilot should be facing the rear of the aircraft.

10. To ensure flight safety, enter the camera view of DJI Pilot 2 and check the parameters on

the pre-flight checklist, such as the failsafe settings, control stick mode, RTH height, and

obstacle distance. It is recommended to set the out-of-control action to RTH.

11. Make sure DJI Pilot 2 is properly opened to assist your operation of the aircraft. WITHOUT

THE FLIGHT DATA RECORDED BY THE DJI PILOT 2 APP, IN CERTAIN SITUATIONS (INCLUDING

THE LOSS OF YOUR AIRCRAFT), DJI MAY NOT BE ABLE TO PROVIDE AFTERSALES SUPPORT

TO YOU OR ASSUME LIABILITY.

12. Divide the airspace for flight when multiple aircraft are operating simultaneously in

order to avoid collision mid-air.

Starting/Stopping the Motors

Starting the Motors

A Combination Stick Command (CSC) is used to start the motors. Push both sticks to the

inner or outer bottom corners to start the motors. Once the motors start spinning, release

both sticks simultaneously.

Stopping the Motors

The motors can be stopped in two ways:

Method 1: when the aircraft has landed, push the throttle stick down and hold. The motors

will stop after three seconds.

Method 2: when the aircraft has landed, push the throttle stick down, and perform the

same CSC used to start the motors. Release both sticks once the motors have stopped.

Method 1 Method 2

① ②